Cut and engraving settings
Open Cuts and Layers and select a layer name to review its settings.
Speed, power and passes
| Setting | What it controls |
|---|---|
| Speed | Programmed feed during the operation. Check the units shown before copying a value from another application. |
| Power | Requested laser output. The active machine profile defines the numeric power scale used by the controller. |
| Passes | How many times to repeat the operation. |
| Line spacing | Distance between adjacent scan rows. Smaller spacing produces more rows over the same area. |
| Output | Whether the layer contributes to the generated job. Check layer visibility too. |
Review the layer settings together
Set the mode first, then check the speed, power, passes and applicable spacing. For repeat work, save your settings with the project and use the material presets and test grid guide. Confirm the active device profile before reviewing or exporting G-code.
Order, kerf, tabs and perforation
Use row order to control which layer runs first. Use advanced settings for contour order or changes to the generated path. See kerf, tabs and perforation and check the result in Preview job.
Line mode and contour settings · Fill mode and scan settings