Work area and job origin

The canvas work area represents the region available for the job. The controller’s machine coordinates and the artwork’s work coordinates can differ.

Before previewing

1. In machine setup, check that the active profile matches the controller and bed dimensions.
2. Confirm where the job’s origin should be relative to the material. Review position and origin settings in the Move or Laser controls before preparing motion.
3. Check the whole design against the work area. Review the selected profile and origin again after importing a project or switching machines.

Check placement

Inspect the software preview first. If the connected machine supports it, use Frame — laser off to check the footprint. See Laser safety and Machine setup before running a frame or dry run.